Shimano XTR MP-M901 M900 1 1/8" Threaded Headset for PARTS

Description: This HP-M901 was assembled from at least two original units, so some parts are borderline new, and some parts are worn or damaged. I believe this could be installed and used as-is, though the bearings wouldn't be perfect due to the upper cup pitting, and the lower race seal wouldn't be perfect due to the chipping on the race edge (and this was pulling it with a proper crown race puller too — apparently they were delicate). At least it's included. For a show bike, or a bike that didn't see riding through lots of mud, this might actually work fine. That said, it's being sold for parts. Here's a condition description of each individual part, top down:Top lock nut - pristine, looks newKeyed lock washer - pristineUpper Head cup - some wear/marring on wrench surfaces, some pitting on the bearing raceBearings and retainer - present with bearings, though the retainer allows some bearings to fall out if loose (this should not be an issue once installed, and grease should be sufficient to seat them for installation) O-ring - present and intactDust seal - present and without visible damage, though it may have deformed slightly over timeUpper head cone - present and without apparent functional damageLower head cup - present and without apparent functional damage. Good cosmetic condition with low wear to logos and finishBearings and retainer - present with bearingsO-ring - present and intactDust seal - present and without visible damage, though it may have deformed slightly over timeLower crown race ("head cone") - bearing contact surface does not appear to have functional damage, but edges are chipped and will not fully seal with the dust sealsThat's pretty thorough, but please feel free to ask if you have any questions. I'd consider parting out the upper and lower, if you only need half.

Price: 60 USD

Location: Portland, Oregon

End Time: 2024-11-17T00:23:01.000Z

Shipping Cost: 0 USD