Offset Axle Panhard Bracket 1/4"

Description: Offset Axle Panhard Bracket 1/4" Part Number:B4WK1050 Description This is our idea of the correct way to make an Offset Panhard / Trackbar bracket, it seems like 3 out of 4 need to be on the leading edge of the axle for clearance issues. The center of the heim will be 6", 7" or 8" vertically from the center of the axle tube and 3.5" forward of the center of the axle tube. They are cut to fit a 3" axle tube so they can be modified to fit any tube diameter, fabricated from 1/4" plate, and bent perfectly so you don't have to play with the grinder to make them fit! They have two drain holes built in. These are setup for a 2" ID and have 5/8 inch bolt holes so just about any heim will fit with minimal misalignment. Additional Images Customer Reviews Mikez This bracket is par or better than the bracket you will get at the self called 'high end' Jeep parts companies. I would not be surprised if this is where most of the company source their brackets from after comparing them side by side. Needless to say this bracket was perfect in every way. I was lucky and able to use the bottom hole for my hydraulic ram and the top for my track bar. Do Not compromise buy Barnes! Reviewed by: (Verified Buyer) mike zeko from California. on 10/6/2015 5/5 Panhard Bracket offset Have several of your pieces and this is as good as the rest. Well made and sturdy. Reviewed by: Wayne Phillips from LaCenter, WA. on 1/5/2014 5/5 Technician Exellent piece, perfect fit and a good finishing! Reviewed by: (Verified Buyer) Angel Baez from San Lorenzo, Puerto Rico. on 11/9/2013 5/5

Price: 33.39 USD

Location: Etowah, North Carolina

End Time: 2024-02-04T14:38:17.000Z

Shipping Cost: 11.95 USD